enable
2. At the command prompt, enter the following command:
show autosave
Example
The following figure provides a sample of the show autosave command.
switch#show autosave
Auto Save: Enabled
Configuring Autosave
The switch performs a check every 60 seconds to detect changes to the configuration file or a new
log message in the nonvolatile storage. If any of these events occurs, the switch automatically saves
its configuration and the nonvolatile log to flash memory. Autosave also automatically saves your
configuration information following restarts.
You can enable or disable the Autosave feature. After you disable autosave, changes in the
configuration file are not saved to the flash memory.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
[no] [default] autosave enable
Variable definitions
The following table describes the parameters for the autosave enablecommand.
Variable
Value
no Disables the autosave feature.
default Returns the autosave feature to the default value.
DEFAULT: Autosave Enabled
Displaying ACLI settings
Display the current ACLI settings such as general console settings, ACLI mode, ACLI user names
and passwords, and password types.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
Configuring the switch using ACLI
62 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
