Chapter 14: Managing Power over Ethernet
(PoE) using EDM
Managing switch PoE using EDM
Use this procedure to display and manage Power over Ethernet (PoE) for a switch unit.
Procedure
1. From the Device Physical View, click a switch unit with PoE ports.
2. From the navigation tree, click Edit.
3. In the Edit tree, click Unit.
4. In the work area, click the PoE tab.
5. In the UsageThreshold%, type a value.
6. In the PoweredDeviceDetectType section, click a radio button.
7. On the toolbar, click Apply.
PoE tab field descriptions
The following table describes the fields on the PoE tab.
Name
Description
Power(watts) Displays the total power (in watts) available to the
switch.
OperStatus Displays the power state of the switch:
• on
• off
• faulty
ConsumptionPower(watts) Displays the power (in watts) being used by the
switch.
UsageThreshold% Lets you set a percentage of the total power usage
of the switch above which the system sends a trap.
Table continues…
148 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
