Avaya 3500 series - IP Office Script

Example
The following figure provides a sample of the show running-config command with the MLT
value.
Switch# show running-config module mlt
Embedded ASCII Configuration Generator Script
! Model = Ethernet Routing Switch 3524T
! Software version = v5.3.0.024
!
! Displaying only parameters different to default
!================================================
enable
configure terminal
!
! *** MLT (Phase 1) ***
!
no mlt
mlt 1 name "Trunk #1" enable member 11-14
mlt 1 bpdu single-port
mlt 1 loadbalance advance
mlt 2 name "Trunk #2" enable member 21-24
!
! *** MLT (Phase 2) ***
!
mlt spanning-tree 1 stp learning fast
mlt spanning-tree 2 stp learning disable
Variable definitions
The following table describes the optional parameters for the show running-config command.
Variable
Value
verbose Displays entire configuration, including defaults and
non-defaults.
module <value> Displays configuration of an application for any of the
following parameters: [802.1AB][aaur] [adac] [arp-
inspection] [asset-id][aur][banner] [core] [dhcp-relay]
[dhcp-server][dhcp-snooping] [eap] [igmp][interface]
[ip] [ip-source-guard] [ipmgr] [ipv6] [l3] [l3-protocols]
[lacp] [logging] [mac-security] [mlt] [poe] [port-
mirroring] [qos] [rate-limit] [rmon] [rtc] [slamon][snmp]
[ssh] [ssl] [stack][stkmon][storm-control] [stp] [vlacp]
[vlan]
IP Office Script
You can use the IPOffice script to quickly and automatically configure parameters for the switch
according to Avaya best practices for converged solutions. The configuration is optimized for
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 53
Comments on this document? infodev@avaya.com