Example
Configuring remote access using EDM
Use this procedure to configure remote access for a switch.
Procedure
1. In the navigation tree, double-click Administration.
2. In the Administration tree, click Remote Access.
3. In the work area, click the Setting tab.
4. In the Telnet Remote Access Setting section, select a value from the Access list.
5. In the Telnet Remote Access Setting section, select a value from the Use List list.
6. In the SNMP Remote Access Setting section, select a value from the Access list.
7. In the SNMP Remote Access Setting section, select a value from the Use List list.
8. In the Web Page Remote Access Setting section, select a value from the Use List list.
9. In the SSH Remote Access Setting section, select a value from the Access list.
10. In the SSH Remote Access Setting section, select a value from the Use List list.
11. On the toolbar, click Apply.
Configuring the switch using EDM
118 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
