Avaya 3500 series - Displaying Poe Power Mode

Example
The following figure provides a sample output of the show poe-main-status command showing
PoE power mode settings.
PoE Main Status - Stand-alone
--------------------------------------------------
Power Mode : Low Power Budget
Available DTE Power : 60 Watts
DTE Power Status : Normal
DTE Power Consumption : 0 Watts
DTE Power Usage Threshold : 80 %
PD Detect Type : 802.3at and Legacy
Power Source Present : AC Only
AC Power Status : Present
DC Power Status : Not Present
Variable definitions
The following table describes the parameters for the poe power-mode command.
Variable Value
low-power-budget | high-power-budget Specifies the power budget mode:
• low-power-budget — for fanless mode
• high-power-budget — for normal mode
DEFAULT — high-power-budget (normal mode)
default Resets the power mode to the default value —
normal mode (high-power-budget)
Displaying PoE power mode
Use the following procedure to display the PoE budget operating mode for the ERS 3510GT-PWR+
switch. There are 2 power budget modes; low (Fanless) or high (Normal).
The default is: high power budget mode (Normal mode, fan operates).
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
show poe-main-status
Displaying PoE power mode
July 2015 Getting Started with Avaya ERS 3500 Series 109
Comments on this document? infodev@avaya.com