Chapter 13: Configuring the switch using
EDM
Configuring the switch using EDM
Configuring Quick Start using EDM
Perform this procedure to configure Quick Start to enter the setup mode through a single screen.
Procedure
1. From the navigation tree, click Administration.
2. In the Administration Tree, click Quick Start.
3. In the In-Band Switch IP address, type a switch address.
4. In the In-Band Subnet Mask dialog box, type a subnet mask.
5. In the Default Gateway dialog box, type an IP address.
6. In the Read-Only Community String box, type a character string.
7. In the Re-enter to verify dialog box immediately following the Read-Only Community String
box, retype the character string from Step 6.
8. In the Read-Write Community String dialog box, type a character string.
9. In the Re-enter to verify dialog box immediately following the Read-Write Community String
box, retype the character string from Step 8.
10. In the Quick Start VLAN dialog box, type a VLAN ID.
11. To enable the DHCP Server, select the ServerEnablecheck box and enter the DHCP server
information.
12. Click Apply.
July 2015 Getting Started with Avaya ERS 3500 Series 117
Comments on this document? infodev@avaya.com
To Next Page
Loading...
