Avaya 3500 series - Displaying Interfaces

Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
[no] banner [custom | static | disabled | <1–19> LINE ]
Variable definitions
The following table describes the parameters for the banner command.
Variable Value
static Displays the default agent-banner
custom Displays the custom agent-banner
disabled Skips the agent-banner display
<1–19> LINE Fills the Nth line of the custom banner (1<N<19) with
the text specified in LINE
no Clears all lines of a previously stored custom banner
Displaying interfaces
You can view the status of all interfaces on the switch, including MultiLink Trunk membership, link
status, autonegotiation, and speed.
Displaying interfaces
Use this procedure to display the current status of all interfaces or for a specific port
The status of all port interfaces on the switch or stack can be viewed, including Mult-Link Trunk
membership, link status, autonegotiation and speed.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show interfaces [admin-disabled | admin-enabled | gbic-info | link-
down | link-up | names| verbose] [<portlist>]
Example
The following figure provides a sample of the show interfaces command with the names
variable.
switch>show interfaces names 1,2,3
Port Name
---- ----
1 LabBldg
Configuring the switch using ACLI
66 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com