Avaya 3500 series - Page 67

2 Testing
3 FloorBldg
The following figure shows a sample output of the show interfaces command without the
names variable.
switch>show interfaces
Status Auto Flow
Port Trunk Admin Oper Link LinkTrap Negotiation Speed Duplex Control
---- ----- ----- ---- ---- -------- ----------- -------- ------ -------
1 Enable Up Up Enabled Custom 1000Mbps Full Disable
2 Enable Down Down Enabled Custom
3 Enable Down Down Enabled Custom
4 Enable Down Down Enabled Custom
5 Enable Down Down Enabled Custom
6 Enable Down Down Enabled Custom
7 Enable Down Down Enabled Custom
8 Enable Down Down Enabled Custom
9 Enable Down Down Enabled Custom
10 Enable Down Down Enabled Custom
The following figure shows a sample output of the show interfaces command with the verbose
variable.
switch>show interfaces verbose
Port: 1
Trunk:
Admin Status: Enable
Oper Status: Up
EAP Oper Status: Up
VLACP Oper Status: Down
STP Oper Status: Forwarding
Link: Up
LinkTrap: Enabled
Link Autonegotiation: Custom
Link Speed: 1000Mbps
Link Duplex: Full=Duplex
BPDU-guard (BPDU Filtering): Disabled
BPDU-guard (BPDU Filtering): Oper Status: N/A
Port: 2
Trunk:
Admin Status: Enable
Oper Status: Down
EAP Oper Status: Up
VLACP Oper Status: Down
STP Oper Status: Discarding
Link: Down
LinkTrap: Enabled
Link Autonegotiation: Custom
BPDU-guard (BPDU Filtering): Disabled
BPDU-guard (BPDU Filtering): Oper Status: N/A
----More (q=Quit, space/return=Continue)----
The following figure shows a sample output of the show interfaces command with the link—up
variable.
switch>show interfaces link-up
Status Auto Flow
Port Trunk Admin Oper Link LinkTrap Negotiation Speed Duplex Control
---- ----- ----- ---- ---- -------- ----------- -------- ------ -------
1 Enable Up Up Enabled Enabled 100Mbps Full Disable
3 Enable Up Up Enabled Enabled 100Mbps Full Disable
13 Enable Up Up Enabled Enabled 100Mbps Full Disable
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 67
Comments on this document? infodev@avaya.com