Avaya 3500 series - Page 68

Variable definitions
The following table describes the parameters for the show interfaces command.
Variable Value
admin-disabled Displays the interfaces with administration disabled.
admin-enabled Displays the interfaces with administration enabled.
gbic-info Displays Gigabit Interface Converter (GBIC) details.
link-down Displays the interfaces with link down.
link-up Displays the interfaces with link up.
names Displays the interface names.
verbose Displays full information about each port.
<portlist> Specifies the ports that you want to display.
Displaying interface configurations
Use this procedure to display the current configuration of all interfaces or for a specific port.
The configuration of all port interfaces on the switch or stack can be viewed, including port
configuration, VLAN interface, VLAN port member, and Spanning-Tree configuration.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show interfaces <portlist> config
Example
The following figure provides a sample of the show interfaces config command.
switch>show interfaces 1/1 config
Unit/Port: 1/1
Trunk:
Admin Status: Enable
Oper Status: Up
EAP Oper Status: Up
VLACP Oper Status: Down
STP Oper Status: Forwarding
Link: Up
LinkTrap: Enabled
Link Autonegotiation: Enabled
Link Speed: 100Mbps
Link Duplex: Full-Duplex
Flow Control: Disable
BPDU-guard (BPDU Filtering): Disabled
BPDU-guard (BPDU Filtering): Oper Status: N/A
*****VLAN interfaces configuration*****
Filter Filter
Untagged Unregistered
Unit/Port Frames Frames PVID PRI Tagging Name
--------- -------- ------------ ---- --- ------------- ----------------
1/1 No Yes 1 0 UntagAll Unit 1,Port 1
Configuring the switch using ACLI
68 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com