Avaya 3500 series - Setting a Power Usage Threshold; Enabling or Disabling Poe Traps

Variable Value
Important:
Ensure that the power detection method you
choose for the ERS 3500–PWR+ matches that
used by the IP devices you are powering.
unit <1–8> Set PD detection mode of an unit in stack
Setting a power usage threshold
Set a percentage usage threshold above which the system sends a trap for each PWR+switch.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
poe poe-power-usage-threshold [unit <1–8>] {<1–99>}
Variable definitions
The following table describes the parameters for the poe poe-power-usage-threshold
command.
Variable
Value
<1–99> Specifies the percentage of total available power you
want the switch to use prior to sending a trap.
DEFAULT: 80%
unit <1–8> Set power usage threshold of an unit in stack
Enabling or disabling PoE traps
Enable or disable the traps for the PoE functions on the PWR+switch.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
Managing Power Over Ethernet (PoE)
104 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com