14 Enable Detecting 0 32 Low
15 Enable Detecting 0 32 Low
16 Enable Detecting 0 32 Low
17 Enable Detecting 0 32 Low
18 Enable Detecting 0 32 Low
19 Enable Detecting 0 32 Low
----More (q=Quit, space/return=Continue)----
Variable definitions
The following table describes the parameters for the show poe-port-status command.
Variable Value
<portlist> Enter the ports for which you want to display the
status. If you omit this parameter, the system
displays all ports.
Displaying PoE power measurement
Display the voltage, current and power values for each powered device connected to each port.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
show poe-power-measurement [<portlist>]
Example
The following figure provides a sample output from the show poe-power-measurement
command.
switch#show poe-power-measurement
Port Volt(V) Current(mA) Power(Watt)
---- ------- ----------- ---------------
1 0.0 0 0.000
2 0.0 0 0.000
3 0.0 0 0.000
4 0.0 0 0.000
5 0.0 0 0.000
6 0.0 0 0.000
7 0.0 0 0.000
8 0.0 0 0.000
9 0.0 0 0.000
10 0.0 0 0.000
11 0.0 0 0.000
12 0.0 0 0.000
13 0.0 0 0.000
14 0.0 0 0.000
15 0.0 0 0.000
16 0.0 0 0.000
17 0.0 0 0.000
18 0.0 0 0.000
19 0.0 0 0.000
Displaying PoE configuration
July 2015 Getting Started with Avaya ERS 3500 Series 107
Comments on this document? infodev@avaya.com
To Next Page
Loading...
