Avaya 3500 series - Displaying the Agent and Diagnostic Software Load

Displaying the agent and diagnostic software load
Display the currently loaded and operational software status for agent and diagnostic loads, either
individually or combined, for a switch or stack.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show boot [diag] [image]
Example
The following figure provides a sample output of the show boot command.
switch>show boot
Unit Agent Image Active Image Diag Image Active Diag
----- ----------- ------------ ---------- -----------
1 5.2.0.037 5.2.0.037 1.0.0.11 1.0.0.11
2 5.2.0.037 5.2.0.037 1.0.0.11 1.0.0.11
3 5.2.0.037 5.2.0.037 1.0.0.11 1.0.0.11
* - Stack requires reboot for new Active Image to be made operational.
# - Stack requires reboot for new Diag to be made operational.
Variable definitions
The following table describes the parameters for the show boot command.
Variable
Value
diag Displays information for the diagnostic load only.
image Displays information for the image load only.
Show software status
July 2015 Getting Started with Avaya ERS 3500 Series 113
Comments on this document? infodev@avaya.com