Avaya 3500 series - Configuring the Operational Mode on Rear Ports; Displaying Operational Mode of the Rear Port

Configuring the operational mode on rear ports
Use this procedure to configure the operational mode of rear ports into Stacking or Standalone
Mode.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
rear-ports mode {standalone | stacking}
Variable definitions
The following table describes the parameters for the rear-ports mode command.
Variable Value
{standalone | stacking} Specifies the operational mode of the rear facing
ports of the selected unit as Standalone or Stacking.
DEFAULT: Standalone
Displaying operational mode of the rear port
Use this procedure to display the operational mode of the rear port on a switch in Standalone or
Stacking Mode.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show rear-ports mode
Example
The following figure provides a sample of the show rear-ports mode command.
switch(config)#show rear-ports mode
Current rear-ports mode: Stacking Mode
Next rear-ports mode: Stacking Mode
Next mode will be applied after reset
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 79
Comments on this document? infodev@avaya.com