Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To enable Stack Forced Mode, enter the following command:
stack forced-mode
3. To disable Stack Forced Mode, enter the following command:
no stack forced-mode
4. To default Stack Forced Mode, enter the following command:
default stack forced-mode
The default is disabled.
Variable definitions
The following table describes the parameters for the stack forced-mode command.
Variable Value
no Disables stack forced-mode
Displaying stack forced-mode
Use this procedure to display the stack forced mode status for the switch. If the status is Enabled,
the device is currently running in stack forced mode. If the status is Disabled, the device is not
running in stack forced mode.
Before you begin
Stack Forced Mode requires a stack configuration of two units.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show stack forced-mode
Example
The following figure provides a sample of the show stack forced-mode command.
switch(config)#show stack forced-mode
Forced-Stack Mode: Disabled
Device is not currently running in forced stack mode.
Configuring the switch using ACLI
78 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
