Command mode and sample
prompt
Entrance commands Exit commands
end
To exit ACLI completely, enter
logout
Quick Start
You can use the install command in ACLI or the Quick Start menu in Enterprise Device
Manager (EDM) to configure the in-band IP Address and netmask, default gateway, read-only and
read-write community strings, quick start VLAN, IPv6 in-band address, IPv6 default gateway and
DHCP server.
Configuring with Quick Start using ACLI
The Install script consists of a series of prompts that are used to set up the minimum
configuration information.
You must enter the following information when prompted:
• IP address
• Subnet mask
• Default gateway
• Read-only community string
• Read-write community string
• Quick start VLAN
• IPV6 address/prefix
• IPV6 default gateway
• DHCP server information (optional)
Before you begin
• Connect to the switch using the terminal or terminal emulation application.
Procedure
1. Press
CTRL + Y to obtain a CLI prompt.
2. Enter enable
3. Enter install
Getting started fundamentals
18 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
