configure terminal
2. At the command prompt, enter the following command:
[no] [default] tftp-server [<A.B.C.D> | <WORD>]
Variable definitions
The following table describes the parameters for the tftp-server command.
Variable Value
<A.B.C.D> Specifies the dotted-decimal IP address of the server
you want to use for TFTP services in the format
XXX.XXX.XXX.XXX.
<WORD> Specifies the IPv6 address of the server you want to
use for TFTP services.
no Clears the TFTP server IP address to 0.0.0.0.
default Sets the TFTP server IP address to 0.0.0.0.
Assigning or clearing the TFTP address
July 2015 Getting Started with Avaya ERS 3500 Series 93
Comments on this document? infodev@avaya.com
To Next Page
Loading...
