Variable Value
port <portlist> Specifies the port numbers to use for flow control
Important:
If you omit this parameter, the system uses the
port number you specified in the interface
command.
asymmetric | auto | disable Sets the mode for flow control:
• asymmetric — enables the local port to perform
flow control on the remote port
• auto — enables auto-negotiation on the specified
port and flow control status will be determined after
the auto-negotiation process completes, depending
on the currently activated auto-negotiation
advertisements
• disable — disables flow control on the port
DEFAULT:auto
no Disables flow control on the specified port(s).
default Sets the flow control to auto, which automatically
detects the flow control on the specified port(s).
Managing Ethernet ports using ACLI
102 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
