Variable Value
Descr Indicates the description for the port.
Type Indicates the media type for the port.
Mtu Indicates the size of the largest packet that can be
sent or received, in octets.
PhysAddress Indicates the MAC address assigned to the port.
AdminStatus Specifies the current administrative state of the port.
Values include:
• up
• down
All ports start in an up state on a managed system.
The AdminStatus changes do down due to
administrator action or the configuration information.
OperStatus Indicates the current operational state of the port.
Values include:
• up — port is ready to transmit and receive traffic
• down — port is not ready to transmit and receive
traffic
• testing — port is currently being tested
LastChange Indicates the value of sysUpTime at the time the
interface entered into the current state. If the current
state occurred before the last reinitialization of the
local management subsystem, the value is zero.
LinkTrap Specifies if traps are generated for this port.
AutoNegotiate Specifies if Autonegotiation is enabled or disabled on
the port.
AdminDuplex Specifies the duplex mode of the port. Values
include:
• half
• full
OperDuplex Indicates the current duplex mode of the port.
AdminSpeed Specifies the speed of the port. Values include:
• mbps10
• mbps100
• mbps1000
• mbps10000
OperSpeed Indicates the current speed of the port.
Table continues…
Configuring the switch using EDM
July 2015 Getting Started with Avaya ERS 3500 Series 123
Comments on this document? infodev@avaya.com
To Next Page
Loading...
