6. In the sysName dialog box, type a system name.
7. In the sysLocation field, type a system location.
8. Perform one of the following:
• To enable authentication traps, select the Authentication Traps check box.
• To disable authentication traps, clear the Authentication Traps check box.
9. In the Reboot section, click a radio button.
10. In the AutoPvid section, click a radio button.
11. In the BootMode section, click a radio button.
12. On the toolbar, click Apply.
System tab field descriptions
The following table describes the fields on the System tab.
Name Description
sysDescr Provides device specific information. This is a read-
only item.
sysUpTime Indicates the amount of time since the system was
last booted.
sysObjectID Indicates the system object identification number.
This is a read-only field.
sysContact Specifies contact information for the system
administrator, which can include a contact name or
email address.
sysName Specifies a unique name to describe this switch.
sysLocation Specifies the physical location of this device.
SerNum Indicates the serial number of this switch.
AuthenticationTraps Enables or disables authentication traps. When
enabled, SNMP traps are sent to trap receivers for
all SNMP access authentication. When disabled, no
SNMP traps are received.
Reboot Options include:
• running: the switch remains in the running mode
(default)
• reboot : initiates a hardware reset.
AutoPVID When enabled, a VLAN ID can be automatically
assigned to any port.
NextBootMgmtProtocol Indicates the transport protocols to use after the next
switch restart. This is a read-only item.
Table continues…
Configuring the switch using EDM
July 2015 Getting Started with Avaya ERS 3500 Series 125
Comments on this document? infodev@avaya.com
To Next Page
Loading...
