Before you begin
Disable the summer time recurring feature.
Procedure
1. In the navigation tree, click Edit.
2. In the Edit tree, click SNTP/Clock.
3. In the work area, click the Daylight Saving Time tab.
4. In the Offset dialog box, type a value.
5. In the TimeZoneAcronymdialog box, type the time zone acronym.
6. In the StartYear dialog box, type a value.
7. In the StartMonth box, select a month.
8. In the StartDay dialog box, type a value.
9. In the StartHour box, select an hour.
10. In the StartMinutes dialog box, type a value.
11. Click Enabled to enable daylight savings time.
12. Click Apply.
13. In the EndYear dialog box, type a value.
14. In the EndMonth box, select a month.
15. In the EndDay dialog box, type a value.
16. In the EndHour box, select an hour.
17. In the EndMinutes dialog box, type a value.
18. Perform one of the following:
• Select the Enabled check box to enable daylight savings time for the switch.
• Clear the Enabled check box to disable daylight savings time for the switch.
19. Click Apply.
Daylight Saving Time tab field descriptions
The following table describes the fields on the Daylight Saving TIme tab.
Name
Description
Offset Specifies the time in minutes by which you want to
change the time when daylight savings begins and
ends. The offset is added to the current time when
daylight savings time begins and subtracted from the
current time when daylight savings time ends.
Table continues…
Configuring the switch using EDM
134 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
