Displaying pluggable ports
Use this procedure to display pluggable ports installed on your switch or stack.
Procedure
1. In the navigation tree, double-click Edit.
2. From the Edit tree, click Chassis.
3. From the Chassis tree, click Switch/Stack.
4. In the work area, click the Stack Info tab.
5. In the work area, click a unit in the Indx column.
6. To display the Pluggable Ports tab, on the toolbar, click Pluggable Ports.
Stack Info field descriptions
The following table describes the fields on the Stack Info tab.
Name Description
Unit Displays the stack unit number where the pluggable
ports are installed
Port Displays the port number in the unit where the
pluggable port is installed
PortType Displays the port type
VendorName Displays the pluggable port vendor name
VendorOUI Displays the pluggable port vendor's OUI
VendorPartNo Displays the vendor's part number for the pluggable
port
VendorRevision Displays the vendor's revision number for the
pluggable port
VendorSerial Displays the vendor's pluggable port serial number
HWOptions Displays hardware options, if present, for the
pluggable port
DateCode Displays the date code for the pluggable port
VendorData Displays vendor data for the pluggable port
OrderCode Displays the order code for the pluggable port
Renumbering stack switch units
Use this procedure to change the unit numbers of switches in a stack.
Procedure
1. In the navigation tree, click Edit.
2. In the Edit tree, click Chassis.
3. In the Chassis tree, click Switch/Stack.
Configuring the switch using EDM
July 2015 Getting Started with Avaya ERS 3500 Series 139
Comments on this document? infodev@avaya.com
To Next Page
Loading...
