Name Description
AdminEnable Lets you enable or disable PoE on this port. By
default, PoE is enabled.
DetectionStatus Displays the operational status of the power-device
detecting mode on the specified port:
• disabled: detecting function disabled.
• searching: detecting function is enabled and the
system is searching for a valid powered device on
this port.
• deliveringPower: detection found a valid powered
device and the port is delivering power.
• fault: power-specific fault detected on port
• test: detecting device in test mode.
• otherFault
Important:
Avaya recommends against using the test
operational status.
PowerClassifications Classification is a way to tag different terminals on
the Power over LAN network according to their
power consumption. Devices such as IP telephones,
WLAN access points, and others can be classified
according to their power requirements.
PowerPriority Lets you set the power priority for the specified port
to:
• critical
• high
• low
PowerLimit(watts) Specifies the maximum power that the switch can
supply to a port.
RANGE: 3 to 32 Watts
DEFAULT: 32 Watts
Voltage (volts) Indicates the voltage measured in Volts.
Current(amps) Indicates the current measured in amps.
Power(watts) Indicates the power measured in watts.
Managing Power over Ethernet (PoE) using EDM
150 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
