About this task
In this scenario, a customer wants to install the Avaya 3526T-PWR and eventually connect the
switch to their network via 802.1q tagging. This section provides an example of setting up the switch
to access the WebGui and how to use the Enterprise Device Manager to configure VLANs for voice
and data traffic on the switch or stack.
On completion of the procedures in this example, the switch will be configured as shown in the
following illustration.
Procedure
1. At the Avaya ERS CLI page, press ctrl + y to start the session.
2. Enter the command Enable.
# indicates you have successfully switched to the privileged administrator mode of
operation.
3. At the ERS CLI, enter the command config t.
User is prompted to enter configuration commands.
4. Input the desired VLAN management IP address and subnet. In this example the IP address
for the switch will be set to the 172.16.10.0 / 24 sub-network.
5. Press Enter.
6. Input the desired VLAN management IP default gateway.
7. Press Enter.
Configuring VLANs for voice and data
July 2015 Getting Started with Avaya ERS 3500 Series 157
Comments on this document? infodev@avaya.com
To Next Page
Loading...
