show terminal
Example
The following figure shows the output from the show terminal command.
Variable definitions
The following table describes the parameters for the terminal command.
Variable Value
speed {2400|4800|9600|19200|38400} Sets the transmit and receive baud rates for the
terminal. You can set the speed to one of the five
options shown.
DEFAULT: 9600
length <1–132> Sets the length of the terminal display in characters.
RANGE: 1 to 132
DEFAULT: 24
width <1–132> Sets the width of the terminal display in characters.
RANGE: 1 to 132
DEFAULT: 79
Connecting to the switch
40 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
