Variable Value
<A.B.C.D > | <dns_host_name> | <WORD> Specifies the IP address, DNS host name, or IPv6
address of the unit to test.
datasize<64–4096> Specifies the size of the ICMP packet to be sent. The
data size range is from 64 to 4096 bytes.
{count <1–9999>} | continuous Sets the number of ICMP packets to be sent. The
continuous mode sets the ping running until the user
interrupts it by entering Ctrl-C.
{timeout |-t} <1–120> Sets the timeout using either the timeout or -t
parameter, followed by the number of seconds the
switch must wait before timing out.
interval<1–60> Specifies the number of seconds between
transmitted packets.
debug Provides additional output information such as ICMP
sequence number and trip time.
source<A.B.C.D> Specifies the source IP address of the packet. Must
be a configured address on the switch.
ttl<0–255> Specifies the maximum hop limit for the packet.
Range of 0 to 255.
Configuring Telnet
50 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
