Figure 12: IP Office logical solution reference diagram
Configuring with IP Office Script
Use this procedure to automatically configure parameters for the switch.
Before you begin
The run ipoffice command executes a script containing many switch configuration parameters to
optimize the switch functions for Converged IP Telephony solutions with Avaya’s IP Office platform.
Executing this ACLI command changes and configures a number of switch configuration options
such as VLAN IDs and port memberships, VLAN IP addresses, default route, QoS and LLDP
settings.
Avaya recommends that the run ipoffice ACLI commands are executed on an switch operating in a
factory default state.
Procedure
1. Log on to ACLI to enter User EXEC mode.
Configuring the switch using ACLI
July 2015 Getting Started with Avaya ERS 3500 Series 57
Comments on this document? infodev@avaya.com
To Next Page
Loading...
