Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
ping <A.B.C.D or Hostname>
Variable definitions
The following table describes the parameters for the ping command.
Variable Value
<A.B.C.D or Hostname> Specifies:
• the IP address of the target device in dotted-
decimal notation (A.B.C.D in the format
XXX.XXX.XXX.XXX)
• the hostname of the device to ping. The hostname
can be a simple name, such as fred; in this case
the DNS domain name, if set, is appended. Or the
hostname can be a full hostname, such as
fred.ca.avaya.com.
DEFAULT: none
Configuring the IP address of a DNS server
Add or remove one or more DNS servers' IP addresses. You can add or remove up to three servers;
one at a time.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
[no] ip name-server <A.B.C.D>
Variable definitions
The following table describes the parameters for the ip name-server command.
Variable
Value
<A.B.C.D> Specifies the IP address of a DNS server to be
added or removed in the format XXX.XXX.XXX.XXX.
DEFAULT: 0.0.0.0
no Removes the specified DNS server name.
Configuring the switch using ACLI
60 Getting Started with Avaya ERS 3500 Series July 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
