CCR 1.0 User Guide Page 82
15-601130 Issue 1k (22 May 2009)IP Office
3.35 Routed to Other
· This statistic is available for queues and agents.
· It shows the number of queue calls to the agent or queue that were subsequently retargeted to or answered by a
party that is not a member of the same queue. For example calls picked up by another user while it was ringing at an
agent.
· It includes calls overflowed from the queue but not calls that overflowed to the queue. It does not include calls that
overflow to a non-IP Office Customer Call Reporter hunt group.
Statistic Settings
All supervisors can customize the settings of each statistic column included in a view. The changes are applied to the
existing data since the last view statistics reset . Click on the statistic name at the top of the column and select
Settings. Customize the statistics settings as required and then click Update.
· Alarms
These controls allow you to select whether a warning and or an alarm is given for the statistic and to set the
threshold levels beyond which those events occur.
· When enabled, the background color of the cells is used to indicate their current alarm state.
· Alarms and warning are updated approximately every 8 seconds.
· Alarms and warnings are automatically cleared when the cell value returns to the threshold level.
· Agents and supervisors can acknowledge alarms and warnings in their views by clicking on the colored
cell. This only affects their view. Acknowledging an alarm also removes it from the alarm list.
· The alarm and warning settings are applied to all cells in the statistic column. When applied to an agent
statistic, the same setting is are applied to the whole column, even when you change which queue's
agents are being viewed.
· Note that when enabling or disabling alarms and warnings, the new settings only get used at the next
change in the value of the relevant cells.
· Warning Threshold
Select to enable a warning threshold and to set that threshold.
· Alarm Threshold
Select to enable an alarm threshold and to set that threshold using the slider control or by entering the
number directly.
82
30
To Next Page
Loading...
