3 Migrating from an S8700 Media Server to an S8710 Media Server
Pre-Migration Setup
142 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
On first S8710 Media Server:
NOTE:
This media server becomes media server 1.
CAUTION:
The duplication cables must not be connected. If connected, disconnect.
1 Power up the media server on page 150
2 Access the media server on page 150
3 Set up Telnet (if necessary) on page 150
4 Install Communication Manager on page 151
5 Access the media server on page 152
6 Check software version on page 152
7 Verify date and time on page 153
8 Copy files to the media server (if any) on page 153
9 Configure the network parameters on page 154
10 Verify connectivity to the network server on page 155
11 Restore the security files on page 156
12 Restore the Linux migration backup files on page 156
13 Install software update (if any) on page 157
14 Verify software update installation on page 158
15 Verify media server configuration on page 158
On second S8710 Media Server:
NOTE:
This media server becomes media server 2.
CAUTION:
The duplication cables must not be connected. If connected, disconnect.
1 Install Communication Manager and restore files on page 159
2 Connect duplication cables on page 159
3 Verify date and time on page 159
4 Install software update, if any on page 159
Move the cables from the S8700 Media Servers to the S8710 Media Servers:
CAUTION:
The following task causes an interruption of service; 2-5 minutes if moving only the
cables, up to 30 minutes if moving the Ethernet switch(es) and UPSs.
To Next Page
Loading...
