Avaya S8500 - Connecting to the Active Media Server; Connecting to the Standby Media Server; Disconnecting from the Standby Media Server; From a PCMCIA Flashcard

Migrating translations
Migrating to the Avaya S8700 or S8710 Media Server 41
June 2004
2 Launch a Web browser.
3 Log in as craft or dadmin.
4 Click Launch Maintenance Web Pages.
5 Under Server, click Release Server.
6 Click Release.
S8700 or S8710
Disconnecting from the standby media server
1 Unplug the laptop from the services port on the back of the standby media server.
Connecting to the active media server
S8700 or S8710
1 Connect to the services port on the back of the active media server.
2 Open a SAT session using Native Configuration Manager or Avaya Site Administration.
3 Login as craft or dadmin.
Installing the translations
1 Type reset system 4 and press Enter.
To add the IPSI translations before saving translations, go to Adding IPSI translations to Communication
Manager on page 47.
From a PCMCIA flashcard
NOTE:
The PCMCIA flashcard is used only with the S8700 Media Server.
Make sure you have the PCMCIA with the translations from Avaya’s Software Technical Support (STS)
group.
Connecting to the standby media server
S8700 only
1 Connect to the services port on the back of the standby media server.
2 Launch a Web browser.
3 Log in as craft or dadmin.
4 Click Launch Maintenance Web Pages.