Converting a processor port network to a port network (MCC)
Migrating to the Avaya S8700 or S8710 Media Server 85
June 2004
Installing Expansion Interface circuit packs
NOTE:
If the existing PPN has a TN776 or TN570 Expansion Interface circuit packs, you must
replace them with a TN570B, vintage 7, or higher circuit pack.
1 Remove the existing circuit pack and place in an antistatic container.
2 Insert the TN570C or higher EI circuit packs into the EXPN INTFC slots (A01, B02).
If reusing the EI circuit pack in a CSS:
1 Move the EI/ATM Interface circuit pack from location C02 to location A01.
2 If critical reliability, move the EI/ATM Interface circuit pack from location D02 to location B02.
If using ATM EIs:
3 Run the fiber optic cables for the expansion interface circuit packs through the media gateway,
using a cable pass-thru kit.
4 Connect the fiber optic cables to the connector on the front of the expansion interface circuit
packs. LED lights up when properly connected.
Powering up the media gateway(s)
1 Power up the media gateways.
2 Remove the emergency ground wire if used.
To Next Page
Loading...
