Migrating hardware
Migrating to the Avaya S8700 or S8710 Media Server 55
June 2004
DEFINITY ECS CSI or DEFINITY ONE/S8100 in
a CMC
You can only migrate a DEFINITY ECS CSI or DEFINITY ONE/S8100 in a Compact Modular Cabinet
(CMC) to an Avaya S8700 or S8710 IP Connect configuration.
When migrating an existing DEFINITY ECS CSI or DEFINITY ONE in a CMC, you use one TN2312BP
IPSI circuit pack to control the port network. If CSI, you replace the TN2182 Tone Clock circuit pack
with the IPSI in the cabinet in the A position; you also remove the processor circuit pack. If DEFINITY
ONE, you replace the processor circuit pack with the IPSI. For specific information on how to do this, see
Converting a processor port network to a port network (CMC)
on page 98.
This is a service-affecting event. The CMCs must be powered down to replace the processor and tone
clock (if csi). Before powering down the cabinets, you must do some premigration administration (see
Preconversion administration (R, SI, CSI)
on page 78 or Preconversion administration (S8100) on page
80 for the specific steps.
Avaya IP600
You can only migrate an Avaya IP600 to an Avaya S8700 or S8710 IP Connect configuration.
When migrating an existing Avaya IP600, you use one TN2312BP IPSI circuit pack to control the port
network. You replace the processor circuit pack with the IPSI in the cabinet in the A position. For specific
information on how to do this, see Converting a processor port network to a port network (IP600)
on page
102.
This is a service-affecting event. The IP600 chassis must be powered down to replace the processor.
Before powering down the chassis, you must do some premigration administration (see Preconversion
administration (S8100) on page 80 for the specific steps.
To Next Page
Loading...
