Avaya S8500 - Converting a Processor Port Network to a Port Network (IP600); Verifying Hardware

Converting a processor port network to a port network (IP600)
102 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
Converting a processor port network to a port network
(IP600)
NOTE:
This section applies to the S8700 IP-Connect configuration only.
NOTE:
If you want to make the system high reliability, then you cannot reuse the IP600 cabinets.
You must install Avaya G650 Media Gateways and move all the circuit packs to the G650.
NOTE:
This section applies only to the S8700 or S8710 IP-Connect configuration.
There is no supported method for moving translations from the existing systems to the S8700 IP Connect
configuration. Everything must be retranslated.
This section covers the following tasks:
• Verifying hardware on page 102
• Converting the IP600 control chassis to a port network on page 103
• Powering down the control chassis on page 104
• Replacing the WP cables on page 104
• Replacing the processor circuit pack on page 106
• Replacing the TN799C C-LAN circuit pack (if necessary) on page 106
• Connecting to the media server on page 106
• Postmigration administration on page 107
Verifying hardware
Make sure you have the conversion specific hardware on hand. See Table 12, Required Migration
Hardware, on page 102 for a list of required hardware.
Table 12: Required Migration Hardware 1 of 2
Comcode Description Quantity
700260359 TN2312BP IP Server Interface circuit pack 1
700263502 IPSI adapter 1
700276389 Maintenance cable (attaches to IPSI adapter—optional) 1
700170012
700178056
700178064
Green CAT5 Ethernet cable:
– 5-meter (16 feet)
– 25-meter (82 feet)
– 50-meter (164 feet)
1
1
1
700060643 TN2302AP IP Media Processor circuit pack 1 or more
700055015 TN799DP C-LAN circuit pack (to replace TN799C) 1 or more