Converting a processor port network to a port network (MCC)
82 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
Converting a processor port network to a port network
(MCC)
NOTE:
This section applies to the S8700 or S8710 Multi-Connect configuration only.
This section covers the following tasks:
• Removing the processor port network control carrier(s) on page 83
• Installing the expansion control carrier and port carrier on page 84
• Installing IPSI and maintenance circuit packs on page 84
• Connecting the CAT5 cables to the IPSI circuit packs on page 84
• Installing Expansion Interface circuit packs on page 85
• Postmigration administration on page 107
Verifying hardware
Make sure you have the conversion specific hardware on hand. See Table 5, Required Migration
Hardware, on page 82 for a list of hardware.
Table 5: Required Migration Hardware
Comcode Description Quantity
J58890-AF-2 L13 Port network expansion control carrier 1
NA CFY1B current limiter (CURL) (if SI,can reuse existing one if R) 1
700260359 TN2312BP IP Server Interface circuit pack 1
700263502 IPSI adapter 1
700276389 Maintenance cable (attaches to IPSI adapter) 1
108865775 TN775D Maintenance circuit pack 1
700168727 Short ribbon cable—from maintenance board to IPSI in MCC1 A
carrier
1
700170012
700178056
700178064
Green CAT5 Ethernet cable:
– 5-meter (16 feet)
– 25-meter (82 feet)
– 50-meter (164 feet)
1
1
1
700060643 TN2302AP IP Media Processor circuit pack 1 or more
700055015 TN799DP C-LAN circuit pack (to replace TN799C) 1 or more
848525887 IP Media Processor adapter 1/MedPro
1/C-LAN
NA CAT5 cables 1/MedPro
1/C-LAN
105679542 Z100C Apparatus blank (optional) 1 or more
To Next Page
Loading...
