Migrating translations
Migrating to the Avaya S8700 or S8710 Media Server 49
June 2004
When using static addressing, in the
Host: field, type in the IP address for the IPSI in the port
network listed in the
Location: field.
S8500 only
S8700 only
3 Verify the correct setting for the IP Control? field
• If IPSIs are in IP-connected PNs, then set the IP Control? field to y.
• If IPSIs are in fiber-connected PNs (CSS or ATM), then set the IP Control? field to y.
• If IPSIs are in fiber-connected PNs (direct-connect), then set the IP Control? field to y
unless there is more than 1 IPSI. Then set the
IP Control? field for the second IPSI to n.
• If an IPSI is in a DS1-C–remoted PN, then set the IP Control? field to n to maintain the
5:1 ratio of IPSIs to PNs. If the field is set to y, then the system decreases the ratio to 2:1.
4 Verify that all the other fields are populated.
5 Press Enter to effect the changes.
6 Repeat steps 1 through 5 for each port network.
Setting IPSI duplication (high/critical
reliability only)
1 Type change system-parameters duplication and press Enter
add ipserver-interface 8
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 8
IP Control? y Socket Encryption? y
Enable QoS? y
Primary IPSI QoS Parameters
------------ --------------
Location: 1A01 Call Control 802.1p: 6
Host: 172.22.22.174 Call Control DiffServ: 46
DHCP ID: ipsi-A01a
Secondary IPSI
--------------
Location: 1B01
Host: 172.22.22.175
DHCP ID: ipsi-A01b
To Next Page
Loading...
