Avaya S8500 - Verify Connectivity to the Network Server

3Migrating from an S8700 Media Server to an S8710 Media Server
On first S8710 Media Server
Migrating to the Avaya S8700 or S8710 Media Server 155
June 2004
Verify connectivity to the network server
To verify that the Ethernet port is working, ping from the media server the network server where the
backup files are stored.
NOTE:
You may need to restart your browser before doing the next steps.
1 Move the Ethernet cable connected to the customer’s network from the busied-out standby S8700
Media Server to the S8710 Media Server (IP: Eth0; MC: Eth4). See Figure 24, Port connections
on the back of the S8710 Media Server, on page 155.
Figure 24: Port connections on the back of the S8710 Media Server
2 Under Diagnostics, click Ping.
3 Select Host Name or IP Address and type the IP address of the server where the system files are
stored
4 Click Execute Ping.
If you can successfully ping the server, then you can restore the backed up Security Files and
Linux migration files.
Figure notes
1 Ethernet 2
2 Ethernet 3
3 Ethernet 4
4 Not used
5 Ethernet 1
6 Ethernet 0
cads87ni KLC 043004
2
3
iLO
VDCI
DAL1 DUP MEMORY
RECEIVE MODE
LINC SYNC
TRANS MODE
LINC ACTIVE
1
2
3
133 MGz
100 MGz
100 MGz
UID
2 1
2 1
5 6
1 32 4