Avaya S8500 - Access the Standby S8700 Media Server; Record the Product ID; Shut down the Standby S8700 Media Server; On First S8710 Media Server

3Migrating from an S8700 Media Server to an S8710 Media Server
On first S8710 Media Server
Migrating to the Avaya S8700 or S8710 Media Server 149
June 2004
Record the Product ID
1 Click Start > Run to open the Run dialog box.
2 Type telnet 192.11.13.6 and press Enter.
3 Log in as craft or dadmin.
4 At the prompt, type productid and press Enter.
Record the product ID for future use.
Access the standby S8700 Media Server
1 Clear the ARP cache on the laptop, if necessary. See Clear the ARP cache on the laptop on page
143 and return here.
2 Disconnect the laptop from media server 1 and connect it to the services port (2) on media
server 2
3 Log in. See Access the media server on page 145 and return here.
4 Repeat Back up the system files on page 147 and Back up the security files on page 148 for media
server 2.
Shut down the standby S8700 Media Server
CAUTION:
Make sure you are connected to the standby media server.
1 Under Server, click Shutdown Server, then Shutdown then
• deselect Restart Server after Shutdown.
• select Delayed shutdown
• select Shut down even if this is the active server.
2 Click Shutdown.
3 Disconnect the laptop from the services port.
4 Disconnect the power cord from the UPS.
On first S8710 Media Server
NOTE:
This media server becomes media server 1.
CAUTION:
The duplication cables must not be connected. If connected, disconnect.