Migrating translations
48 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
An Asterisk (*) to the right of the Subnet Address field means that although a subnet address is
displayed, it is not the correct one; the Communication Manager call processing software does not
have the subnet information. After verifying the displayed information, submit this form with or
without changes to update the Communication Manager with the correct subnet information.
CAUTION:
If the information displayed in the Primary Control Subnet Address and/or Secondary
Control Subnet Address
fields is not correct, it must be changed on the media servers.
Use the Maintenance Web Interface; under Server Configuration and Upgrades, click
Configure Server to change the media server configuration. Then return here to perform
this step.
3 Verify that the Switch Identifier is set correctly for this installation. It is critical that the correct
Switch Identifier is entered here before TN2312 IPSI circuit packs are administered.
4 Verify that the IPSI Control of Port Networks: field is set to disabled.
5 Press Enter to submit the form.
NOTE:
The information you provide differs, depending on whether the IPSIs get static addresses
or they are assigned automatically through DHCP.
Adding IPSI information
1 Type add ipserver-interface PNnumber where PNnumber is the port network number and press
Enter to add the IPSI circuit pack information.
2 When using a DHCP server, verify that the fields associated with the Primary IPSI and Secondary
IPSI (if equipped) are populated with default data.The
Host: and DHCP ID: fields are set by the
DHCP server.
add ipserver-interface 4 Page 1 of 1
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 4
IP Control? y Socket Encryption? n
Enable QoS? n
Primary IPSI
------------
Location: 9A01
Host: ipsi-A09a
DHCP ID: ipsi-A09a
Secondary IPSI
--------------
Location: 9B01
Host: ipsi-A09b
DHCP ID: ipsi-A09b
To Next Page
Loading...
