Converting a processor port network to a port network
Migrating to the Avaya S8700 or S8710 Media Server 81
June 2004
Note IP settings
Note the IP settings assigned to the processor as they may be used for the Avaya S8700 or S8710 Media
Server. Verify against the filled-out Electronic Preinstallation Worksheet.
The following administration is done on the services laptop connected to the processor circuit pack using
telnet.
1 Select Start > Run to open the Run dialog box.
2 Type telnet 192.11.13.6 and press Enter to access the Avaya IP600.
3 Log in as lucent3 to get to the LAC prompt.
4 Type bash and press Enter to start a BASH session.
5 Type setip and press Enter to display the current list of IP settings. You will see the following
information:
• cust: IPaddress, subnet mask, gateway
• dns: server name, domain name, 2 DNS server IP addresses
• wins: 2 WINS server IP addresses
• ras: 1 remote access server IP address
6 Write down this information, exactly as it appears.
You must record this information exactly as it appears here. You cannot miss any periods, commas, or
other punctuation marks. Record information in lower or upper case as it appears.
To Next Page
