Avaya S8500 - Converting a Processor Port Network to a Port Network (SCC); Verifying Hardware

Converting a processor port network to a port network (SCC)
86 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
Converting a processor port network to a port network
(SCC)
NOTE:
This section applies to the S8700 or S8710 Multi-Connect configuration only.
This section covers the following tasks:
• Verifying hardware on page 86
• Removing the processor port network control cabinet on page 87
• Installing the expansion control media gateway on page 88
• Stacking the port media gateways on page 88
• Installing IPSI and maintenance circuit packs on page 88
• Connecting the CAT5 cables to the IPSI circuit packs on page 88
• Installing Expansion Interface circuit packs on page 88
• Postmigration administration on page 107
Verifying hardware
Make sure you have the conversion specific hardware on hand. See Table 6, Required Migration
Hardware, on page 86 for a list of hardware.
Table 6: Required Migration Hardware 1 of 2
Comcode Description Quantity
J58890N Port network expansion control carrier 1
NA CFY1B current limiter (CURL) (if SI; can reuse existing
one if R)
1
700260359 TN2312BP IP Server Interface circuit pack 1
700263502 IPSI adapter 1
700276389 Maintenance cable (attaches to IPSI adapter) 1
108865775 TN775D Maintenance circuit pack 1
700168727 Short ribbon cable—from maintenance board to IPSI in
MCC1 A carrier
1
700170012
700178056
700178064
Green CAT5 Ethernet cable:
– 5-meter (16 feet)
– 25-meter (82 feet)
– 50-meter (164 feet)
1
1
1
700060643 TN2302AP IP Media Processor circuit pack 1 or more
700055015 TN799DP C-LAN circuit pack (to replace TN799C) 1 or more
848525887 IP Media Processor adapter 1/MedPro
1/C-LAN