Avaya S8500 - Powering down the Control Cabinet; Replacing the Processor Circuit Pack; Replacing the TN799 C C-LAN Circuit Pack (if Necessary)

Converting a processor port network to a port network (CMC)
100 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
Powering down the control cabinet
CAUTION:
Make sure you have done the premigration administration. See Preconversion
administration (R, SI, CSI) on page 78 if csi or Preconversion administration (S8100) on
page 80 if S8100.
1 Press and hold the shutdown button on the processor’s faceplate until the shutdown process starts.
Make sure you see the green light indicating the system has shut down before continuing.
!
DANGER:
The latch on the power supply acts as the DC power switch and only removes DC
power from the backplane, not the AC power. To remove the AC power from the
cabinet, pull the AC power cord from the back of the cabinet.
2 Power down the cabinet by unplugging the power cord from the back of the cabinet.
Replacing the processor circuit pack
1 Remove the entire processor circuit pack and place it in an antistatic carrier or bag. You want it
intact if you need to back out of the migration.
2 If csi, remove the TN2182 Tone Clock circuit pack.
3 Remove the octopus cable from the connector associated with slot 2 on the connector panel.
4 Install the IPSI adapter to the connector associated with slot 2 on the connector panel.
5 Install the maintenance cable onto the 9-pin D-sub connector on the Adapter. This cable is for
emergency transfer and "auxsig" signal.
NOTE:
The TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack takes up only one
slot.
6 Insert the TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack into slot 2.
7 Attach the new label above the circuit pack slots.
Replacing the TN799C C-LAN circuit pack (if
necessary)
1 Remove the TN799C Control-LAN (C-LAN) circuit pack and place it in an antistatic carrier or
bag.
2 Insert the new TN799DP C-LAN circuit pack into the same slot.
3 Replace the 259A adapter and CAT3 cable on the connector panel with the Amphenol adapter
used for the TN2302AP IP Media Processor circuit pack and a CAT5 cable.