Avaya S8700 - Page 101

101
Installing the S8700 IP Connect
May 2002
Administer the node names
1 Type change node-names ip and press Enter.
The IP Node Names screen appears. Use this screen to administer the circuit pack’s node
name.
2 Type a unique name in the Name field.
This name is recognized only within the MultiVantage software and does not need to
match the node name on your network.
3 Enter the IP Address.
Get this information from the network administrator or refer to the job aid entitled
Pre-Installation Network Worksheet—S8700 IP Connect or Pre-Installation Network
Worksheet—S8700 Multi-Connect.
4 Press Enter to save the changes.
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
Tiki 172.22 .22 .79 . . .
cdr_1 192.168.22 .63 . . .
default 0 .0 .0 .0 . . .
iolan 172.22 .22 .68 . . .
lulu_cl1 172.22 .22 .71 . . .
lulu_cl2 172.22 .22 .77 . . .
riki 172.22 .22 .20 . . .
rsat4 172.31 .5 .49 . . .
rsat5 172.23 .23 .40 . . .
st10clan#1 192.168.22 .21 . . .
st12clan 172.22 .22 .67 . . .
st12prowler#1 172.22 .22 .75 . . .
VAL#1 172.22 .22 .120 . . .
. . . . . .
. . . . . .
. . . . . .
( 12 of 12 administered node-names are displayed)
Use ’list node-names’ command to see all the administered node-names
Use ’change node-names ip xxx’ to change a node-name ’xxx’ or add a node-name