163
Installing the S8700 IP Connect
May 2002
Connecting the Hardware
This section covers the following tasks:
• ‘‘Connect the Ethernet Switch Cables to the IPSI Circuit Packs’’ on page 163
• ‘‘Set IPSI Static IP Addresses’’ on page 163
Connect the Ethernet Switch Cables to the IPSI
Circuit Packs
Connect one end of the GREEN CAT5 cable to the Ethernet switch and the other to the IPSI
adapter on the back of media gateway A. Refer to Getting Started with the
Avaya™ S8700
Media Server for IP Connect Configurations for a connectivity guide.
Set IPSI Static IP Addresses
For IP Connect Configurations the IPSI circuit packs get static IP addresses, which are
adminstered directly through the Ethernet port connection on the IPSI faceplate (top port). See
‘‘Connecting directly to the IPSI’’ on page 163
.
Connecting directly to the IPSI
Figure notes
1 Services laptop
2 PCMCIA Network Interface Card (NIC)
3 NIC adapter cable (if necessary)
4 Green CAT5 cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
