76
Installing the S8700 IP Connect
May 2002
Circuit Pack Installation
!
CAUTION:
When handling circuit packs or any components of an Avaya G600 Media Gateway,
always wear an authorized wrist ground strap. Connect the strap to the ground connector
provided on the media gateway.
Circuit Pack Slot Loading
1 Check the reinstalled circuit packs. All of the circuit pack slots in the Avaya G600 are
“universal slots.” Any slot can contain any type of port circuit pack except that the
TN2312AP IP Server Interface circuit pack must be installed in slot 2 of media gateway
A. See ‘‘Avaya G600 Media Gateway and slot numbering’’ on page 77
.
2 Load all port circuit packs. See ‘‘Circuit pack installation order (loading)’’ on page 77
for the recommended circuit pack layout.
TN1657 Disk Drive No
TN2169 Alarm Interface No
TN2170 Ethernet Interface No
TN2182/B Tone-Clock - Tone Detector and Call Classifier No
TN2198 ISDN-BRI 2-Wire U Interface No
TN2202 50-Hz French Ring Generator No
TN2208 AUDIX No
TN2210 Tone Generator No
TN2214/B Digital Line, 24-Port, 2-Wire DCP - Category B only No
TN2215 Analog Line, 16-Port 2-Wire - Category B only No
TN2238 ATM Trunk Interface (Multi-Mode) No
TN2301 Survivable Remote Logic Switch No
TN2305/2306 ATM Interface (Single-Mode) No
TN2308 Direct Inward Dialing Trunk No
TN2401 Network Control/Packet Interface No
TN2404 Processor No
Non-Allowable Circuit packs and Circuit Modules — Continued
Apparatus code Name Allowable
To Next Page
Loading...
