Avaya S8700 - Verify Timing to the Media Server; Resolve Alarms

201
Installing the S8700 IP Connect
May 2002
Verify Timing to the Media Server
1 To administer the Stratum 3 clock, type change synchronization and press Enter.
2 Type 3 in the stratum field.
3 Type the port network number where the TN780 Tone-Clock circuit packs reside in the
port network field.
NOTE:
Wait 1 minute for the software to reconfigure the media server synchronization.
4 Verify the results of test 649. If test 649 fails with a code of 2101, then check the wiring
for EXTSYN0 and EXTSYN1. Refer to the maintenance book for your configuration
.
If test 649 is successful, then the media server is getting correct timing from the Stratum 3
clock.
Resolve Alarms
As a last step, inspect the alarms log.
Use the media server web interface.
1 Click on View Current Alarms and see if any alarms were generated. If so, resolve any
alarms that may exist using the maintenance book for your configuration
.
PAI ST B Replace the ST3 card
CI FAIL Check wiring for its associated DS1 reference and replace the
circuit pack if necessary
ST3 FAIL Replace the circuit pack
ST3 LOCK Ignore this LED
ST3 HOLDOVER Ignore this LED
ST3 FREE RUN Ignore this LED
TOC
A
FAIL Replace the circuit pack
TOC
A
PORT ALM Replace the circuit pack if necessary
Stratum 3 Clock LED Indicators — Continued
Card LED Label Procedure