160
Installing the S8700 IP Connect
May 2002
The P333T-PWR has 24 10/100Base-T ports, each of which can supply up to 16.5W using the
internal power supply and operates on a 100-240 VAC, 5.3A, 50/60 Hz power source with the
option of using the 44~57 VDC, 15A to boost the InLine power.
The P333T-PWR can be placed in a wiring closet or on a flat, stable surface like a desk. Screws
are provided for mounting in a standard 19-inch rack.
Connect the P333T-PWR
Power up—AC input
1 Insert the power cord into the power connector (BUPS or Power Supply) on the rear of
the unit. See Figure.
2 Insert the other end of the power cord into the electricity supply or the connector on the
BUPS.
The unit powers up and performs a self-test procedure. The LEDs flash at regular
intervals after the self-test procedure is completed successfully.
Power up—DC input (optional)
The P333T-PWR can operate on the AC input only. However, you may wish to use the optional
DC input for the following:
• Backup for the Power over Ethernet ports
• To provide more than 200W for the Power over Ethernet ports
NOTE:
Please refer to the P333T-PWR User’s Guide for more information.
Figure notes
1 BUPS connector AC connector
1
2
psdlups KLC 032002
To Next Page
Loading...
