179
Installing the S8700 IP Connect
May 2002
S8700 Media Server LEDs
The media server has the LEDs shown in ‘‘LEDs on front and back of media server’’ on page
179:
LEDs on front and back of media server
Testing the Media Server LEDs
You can test some of the LEDs on the front of the media server through the media server web
interface. This makes sure that the
Active/Standby and U2 LEDs (on the front of the media
server) and the transmit LED on the DAJ1 duplication memory card (on the back of the media
server) are controllable and not burned out and that the media server is not hung.
NOTE:
The U2 LED is controlled by the S8700 Media Server but does not have an assigned
function.
The other LEDs are exclusively under hardware control so will not flash during the test. Refer
to the OEM user documentation that comes with the media server for information on those
LEDs.
Figure notes
1 Power
2 Configuration fault
3 Hard drive activity
4 Network activity (CNA)
5 Service—configuration health
6 Active or standby mode indicator
7 U2 (not defined)
8 4 NIC ports (the numbers indicate
their assigned Ethernet ports)
9 LEDs for the NIC ports
10 LEDs for fiber optic duplication
connectivity
11 Status LED (not used)
1
SERVICE
U2
STANDBY
ACTIVE
2
1
55 44 33
22
DAI - 1
DUP
MEMORY
LINE
RECEIVE
TRANS
LINK
STAT
AVAYA
1 2
3 44 5
6
7
9
10
11
8
scdlled KLC 030502
To Next Page
Loading...
