37
Installing the S8700 IP Connect
May 2002
Administer the IP Server Interface
NOTE:
Do this procedure only if the translations were not input earlier.
The following administration uses the services laptop computer connected to the active media
server and uses Avaya Site Administration.
1 Type change system-parameters ipserver-interface and press Enter.
2 Set the Switch Identifier: field to the switch ID letter (A thru J; A is the default
setting).
3 Set the IPSI Control of Port Networks: field to enabled.
4 Type add ipserver-interface PNnumber and press Enter to add the IPSI circuit pack
information.
5 In the Host: field, type in the static IP address for the IPSI in that port network.
change system-parameters ipserver-interface Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix:
Primary Control Subnet Address: 172. 22. 0. 0*
Secondary Control Subnet Address: . . .
OPTIONS
Switch Identifier: A
IPSI Control of Port Networks: enabled
NOTE: * indicates data changed on the Server
add ipserver-interface 1
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 1
Socket Encryption? y
Primary IPSI QoS Parameters
------------ --------------
Location: 1A02 Call Control 802.1p: 6
Host: 172.22.22.174 Call Control DiffServ: 46
DHCP ID: ipsi-A01a
To Next Page
Loading...
