59
Installing the S8700 IP Connect
May 2002
Cabling the Media Gateways
After mounting the media gateways in the rack, you must connect the TDM/LAN cables
between the media gateways. You must also connect CAT5 cables to the appropriate slots on the
back of the media gateways.
NOTE:
TDM/LAN bus terminators are factory installed on a single Avaya G600 Media Gateway.
See ‘‘Media gateway A TDM/LAN bus terminators’’ on page 59
Media gateway A TDM/LAN bus terminators
Cabling Multiple Media Gateways
You can mount and cable up to 4 media gateways in a rack. The media gateway on the bottom is
referred to as media gateway A. The others are referred to as media gateways B, C, and D from
bottom to top.
When cabling the media gateways together, refer to the TDM Cable Installation Diagram
included with the shipment.
Figure notes
1 TDM/LAN bus terminators (at each
end of the TDM/LAN bus)
TO
P
TO
P
cadptdm1 KLC 102600
1 1
A
To Next Page
Loading...
