Avaya S8700 - Completing the Installation Administration

166
Installing the S8700 IP Connect
May 2002
Completing the Installation
Administration
This section covers the following tasks:
• ‘‘Verify Translations’’ on page 166
• ‘‘Verify Connectivity’’ on page 166
• ‘‘Upgrade the IPSI Firmware (if necessary)’’ on page 167
• ‘‘Enable and Disable Ethernet Switch Ports’’ on page 167
• ‘‘View Alarms’’ on page 168
• ‘‘Back Up the Media Server’’ on page 169
• ‘‘Release Busied Out Server’’ on page 170
• ‘‘View Alarms’’ on page 170
• ‘‘Register the System’’ on page 170
Verify Translations
The following administration is done on a computer used to access the Avaya S8700 Media
Server using Avaya Site Administration.
1 Type list configuration all and press Enter to view all the administered circuit packs in
the system.
2 Type list ipsi and press Enter to verify the location of the IPSI circuit packs.
3 Check the administration status on the following items:
• list station
• list trunk-group
• list hunt-group
Verify Connectivity
The following administration is done on a computer used to access the active media server
using the media server web interface.
NOTE:
We recommend you be on the active media server.
1 Click Execute Pingall and select "Other server(s), All IPSIs, UPS(s), Ethernet
switches." to verify connectivity to these units.